A practical reference on heptapeptide: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-08-01 and is reviewed periodically as new material appears.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro. Its four N-terminal residues reproduce tuftsin, a tetrapeptide fragment of the immunoglobulin heavy chain, while the C-terminal Pro-Gly-Pro extension is a synthetic addition. The peptide has a molecular mass near 752 daltons and carries a net positive charge at physiological pH because of the arginine and lysine side chains. Published indexes list it under the name Selank and the sequence abbreviation TKPRPGP. Solid-phase peptide synthesis is the standard production route for research quantities.
Development took place at the Institute of Molecular Genetics of the Russian Academy of Sciences, where a series of short peptides were designed in the 1980s and 1990s. Selank was selected from variants of tuftsin that showed resistance to plasma peptidases. Russian regulatory approval covers it as an anxiolytic agent given intranasally. Outside that market the compound is normally handled as a research chemical rather than a medicine, and no widely recognised international pharmacopoeial monograph exists. The name Selank is a coined trade designation rather than a systematic chemical name.
Lyophilized selank is normally supplied as a dry powder and is considered stable for extended periods when kept cold and dry. Moisture uptake is the main practical threat, because absorbed water promotes both hydrolysis and aggregation in the solid state. Vials are usually warmed to room temperature before opening so that condensation does not form on the powder. Supplier documentation commonly specifies -20 °C for routine storage, with -80 °C used for material intended to be archived for years.
Once dissolved, the peptide is markedly less stable than the dry powder. Aqueous solutions are subject to backbone hydrolysis and to microbial growth when they are handled without sterile technique. Buffered solutions near neutral pH are common for short-term laboratory work, while acidic conditions are sometimes used to improve solubility. Analytical laboratories generally prepare working solutions fresh rather than storing them, and a residual water film left in a reopened vial can seed degradation even when the container appears dry.
Reversed-phase high-performance liquid chromatography is the standard technique for estimating peptide purity. The result is a peak-area percentage, which describes how much of the detected material elutes as the main peak in one run. Mass spectrometry confirms the molecular mass and can reveal truncated, adducted, or otherwise modified species. Amino acid analysis or tandem mass spectrometry can address sequence fidelity when identity is in doubt. None of these measurements, taken alone, establishes that a sample is fit for any specific purpose.
| Property | Value | Notes |
|---|---|---|
| Chemical class | Synthetic heptapeptide | Tuftsin analogue with a C-terminal Pro-Gly-Pro tail |
| Amino acid sequence | Thr-Lys-Pro-Arg-Pro-Gly-Pro | Abbreviated TKPRPGP in most catalogues |
| Molecular mass | About 752 Da | Value for the free peptide |
| Solubility | Freely soluble in water | Aqueous solutions are kept cold and used promptly |
| Typical storage | -20 °C, dry, protected from light | Applies to the lyophilised powder before reconstitution |
Selank is a synthetic heptapeptide developed in Russia as a structural analogue of tuftsin, a naturally occurring immunomodulatory tetrapeptide. Its sequence, Thr-Lys-Pro-Arg-Pro-Gly-Pro, keeps the tuftsin core at the N-terminus and appends a Pro-Gly-Pro tail. Researchers at the Institute of Molecular Genetics in Moscow synthesized the compound during the 1990s while searching for peptides with combined anxiolytic and immunomodulatory activity. The added tail was intended to resist enzymatic cleavage and prolong the molecule's presence in circulation.
The compound has a calculated molecular weight near 751.9 daltons and carries a net positive charge at physiological pH because of its arginine residue. It dissolves freely in water and in common aqueous buffers, and typically appears as a white or off-white lyophilized powder. The amide backbone makes the molecule susceptible to peptidases, which limits oral use and favors intranasal or parenteral routes. Nomenclature in the literature varies: the substance is also described by the sequence abbreviation TP-7 and by a Russian trade designation.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro, written TKPRPGP in one-letter notation. Its structure consists of the immunomodulatory tetrapeptide tuftsin, Thr-Lys-Pro-Arg, extended at the carboxyl terminus by a Pro-Gly-Pro segment. The molecular formula is commonly given as C33H57N11O9, corresponding to a monoisotopic mass near 751.4 Da and an average molecular mass near 751.9 Da. All seven residues are proteinogenic amino acids, and the molecule carries no modified side chains or non-natural linkages.
The compound was designed at the Institute of Molecular Genetics of the Russian Academy of Sciences during the 1980s and 1990s. The stated design goal was to retain the immunomodulatory and central nervous system activity attributed to tuftsin while improving resistance to enzymatic breakdown. Adding a proline-rich tail to the short parent peptide was a deliberate strategy, because proline residues restrict the conformations available to many peptidases. The same laboratory produced Semax, an ACTH fragment analog, and both compounds were developed in parallel as short, enzymatically stabilized peptides intended for intranasal use.
Development work on the compound began in the 1980s and 1990s at the Institute of Molecular Genetics in Moscow, within the same research programme that produced the peptide Semax. Early investigators sought a tuftsin derivative with improved resistance to enzymatic breakdown and with activity in the central nervous system after peripheral administration. Most of the primary literature from this period was published in Russian, a factor that still shapes how easily the findings can be checked by outside groups.
Naming for this compound is not fully standardised in English sources. The spelling Selanc appears in some transliterations, and catalogue entries may instead list the peptide sequence itself as the identifier. Reference material sometimes groups it with other short synthetic peptides studied for behavioural effects, which can create confusion when citations are compared. Distinguishing the exact sequence from related tuftsin analogues is therefore a practical first step when reviewing any dataset or specification sheet.
Solubility behavior is a practical concern for handling. Selank dissolves readily in water and in common aqueous buffers, which simplifies preparation of working solutions. The choice of solvent, ionic strength, and pH can influence aggregation over time, particularly at higher concentrations. Aqueous solutions are typically sterile-filtered before use. Because stability depends on several variables, storage and handling notes should be treated as general guidance rather than fixed rules, and specific values are best confirmed against a certificate of analysis for each batch.
Characterization of Selank in a laboratory setting relies on standard peptide methods. Reverse-phase high-performance liquid chromatography separates the target from related impurities and provides a purity figure, commonly reported as 95 percent or higher. Mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, confirms the molecular mass and helps detect truncation or modification. Amino acid analysis can verify composition when a sequence-level check is needed. These techniques together establish identity and purity for a given lot.
Lyophilized Selank, the dry powder form, is generally stored frozen at minus 20 degrees Celsius or colder for long-term keeping. The solid is hygroscopic and should stay sealed, dry, and protected from light. Once dissolved, the peptide is less stable and is usually held refrigerated at 2 to 8 degrees Celsius for short periods. Repeated freezing and thawing is avoided because it can promote aggregation and loss of activity. Buffers and pH choice also affect how long a solution remains usable.
When they find it, the teams follow the trails, tracking the fighters for days across miles of uninhabited wilderness until they make contact. Matching these generic terrain-feature descriptions to specific GPS markers enabled SOCAFRICA to build a map of the area. The results enable the Green Berets to anticipate LRA movements. Commanders have used this knowledge to carry out operations that have sharply reduced the remnants of the LRA.
== Introduction == The field of biotextiles has garnered significant attention due to its potential to revolutionize the textile industry by offering sustainable alternatives to conventional and environmentally harmful fabrics. Central to this innovation are raw materials derived from nature's own processes, including mycelium, bacterial cellulose and vegetable and fruit biomass. These natural ingredients have potential to become a reliable source for the development of eco-friendly textiles, addressing issues with environmental degradation and ingredient depletion associated with traditional textile production. Processing of these materials offer abundant sources of natural fibers. Using the fibrous structures found in these materials and plant tissues, such as cotton, hemp, flax and more, its possible to create biodegradable and renewable textiles. Washing, drying and a variety of spinning techniques are common for processing of all textiles but the processing for biotextiles is expected to produce less environmentally harmful waste products due to the bio-remedial nature of many of the natural materials. Furthermore, advancements in processing have enabled the extraction of fibers for fashion from unconventional sources, including pineapple, banana, citrus fruits, animal byproducts and bone. These new developments make large contributions to the world of innovative fashion.
=== Industrial synthesis === Nicotinic acid was first synthesized in 1867 by oxidative degradation of nicotine with potassium chromate and sulfuric acid — this is the origin of the name. Nicotinic acid is prepared by hydrolysis of nicotinonitrile, which, as described above, is generated by oxidation of 3-picoline. Oxidation can be effected by air, but ammoxidation is more efficient. In the latter process, nicotinonitrile is produced by ammoxidation of 3-methylpyridine. Nitrile hydratase is then used to catalyze nicotinonitrile to nicotinamide, which can be sold directly or converted to nicotinic acid. Alternatively, ammonia, acetic acid and paraldehyde are used to make 5-ethyl-2-methyl-pyridine, which is then oxidized to nicotinic acid. New "greener" catalysts are being tested using manganese-substituted aluminophosphates that use acetyl peroxyborate as non-corrosive oxidant, avoiding producing nitrogen oxides as do traditional ammoxidations. The demand for commercial production includes for animal feed and for food fortification meant for human consumption. According to Ullmann's Encyclopedia of Industrial Chemistry, worldwide 31,000 tons of nicotinamide were sold in 2014.
Sources: en.wikipedia.org
== Chemistry == Chemically, dipipanone belongs to the class of opioids called the 4,4-diphenylheptane-3-ones. It closely resembles methadone, the only structural difference being the N,N-dimethyl moiety of methadone being replaced with a piperidine ring. Other related compounds with equivalent activity where the piperidine ring has been replaced by other groups, include the morpholine derivative phenadoxone, as well as the corresponding pyrrolidine derivative dipyanone. The synthesis is the same as for phenadoxone, with the exception that piperidine is used in lieu of morpholine. Related compounds with an isoquinuclidine ring such as nufenoxole are also known.
=== Compounds === Solid radium compounds are white as radium ions provide no specific coloring, but they gradually turn yellow and then dark over time due to self-radiolysis from radium's alpha decay. Insoluble radium compounds coprecipitate with all barium, most strontium, and most lead compounds. Radium oxide (RaO) is poorly characterized, as the reaction of radium with air results in the formation of radium nitride. Radium hydroxide (Ra(OH)2) is formed via the reaction of radium metal with water, and is the most readily soluble among the alkaline earth hydroxides and a stronger base than its barium congener, barium hydroxide. It is also more soluble than actinium hydroxide and thorium hydroxide: these three adjacent hydroxides may be separated by precipitating them with ammonia. Radium chloride (RaCl2) is a colorless, luminescent compound. It becomes yellow after some time due to self-damage by the alpha radiation given off by radium when it decays. Small amounts of barium impurities give the compound a rose color. It is soluble in water, though less so than barium chloride, and its solubility decreases with increasing concentration of hydrochloric acid. Crystallization from aqueous solution gives the dihydrate RaCl2·2H2O, isomorphous with its barium analog. Radium bromide (RaBr2) is also a colorless, luminous compound. In water, it is more soluble than radium chloride. Like radium chloride, crystallization from aqueous solution gives the dihydrate RaBr2·2H2O, isomorphous with its barium analog.
Methylenedioxypyrovalerone (MDPV) is a psychoactive drug with stimulant properties that acts as a norepinephrine–dopamine reuptake inhibitor (NDRI). It was first developed in the 1960s by a team at Boehringer Ingelheim. MDPV remained an obscure stimulant until around 2004, when it was reported to be sold as a designer drug. Products labeled as bath salts containing MDPV were previously sold as recreational drugs in gas stations and convenience stores in the United States, similar to the marketing for spice and K2 as incense. Incidents of psychological and physical harm have been attributed to MDPV use.
Sources: en.wikipedia.org
Selank is a seven-amino-acid peptide built from the tuftsin sequence plus a Pro-Gly-Pro tail. It is produced by chemical synthesis rather than extracted from a natural source. The free peptide is usually supplied as a lyophilised powder or in an aqueous formulation.
Tuftsin is a natural tetrapeptide derived from the Fc portion of immunoglobulin G. Selank retains that tetrapeptide at its N-terminus and adds three residues to improve resistance to enzymatic breakdown. The relationship is structural, and the two molecules are not interchangeable in experimental work.
It holds a product registration in Russia for intranasal use as an anxiolytic. Registrations of that kind are not automatically accepted by regulators elsewhere. In most other countries it is treated as an unapproved substance or a research material.
Sealed, desiccated storage at -20 °C or colder is the standard recommendation for research-grade material. Vials should reach room temperature before they are opened, which limits condensation. Repeated temperature cycling is discouraged.