A practical reference on RP-HPLC: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-08-01 and is reviewed periodically as new material appears.
Peptide purity testing uses separation methods to estimate the proportion of a sample that corresponds to the target sequence. Reverse-phase high-performance liquid chromatography is the most common technique, separating peptides by hydrophobicity on a nonpolar column. Ultraviolet detection at 214 nm records peptide bonds and aromatic residues. The resulting chromatogram is reported as area percent, which reflects relative absorbance rather than absolute mass. This distinction matters because water, counterions, and residual solvents do not appear in the peptide peak.
Mass spectrometry provides an identity check that complements chromatographic purity. Electrospray ionization or matrix-assisted laser desorption/ionization measures the mass-to-charge ratio of intact peptides. A match to the expected molecular mass supports correct sequence length and terminal groups. Mass accuracy alone does not prove that every peak in a liquid chromatogram is the target peptide. It also does not directly quantify how much water or counterion remains in a lyophilized powder.
Handling practices strongly affect measured purity and sample integrity. Many peptides are hygroscopic, susceptible to oxidation, or prone to adsorption on glass and plastic surfaces. Lyophilized powders are typically stored desiccated at -20 °C or below, while solutions may require colder storage and minimized freeze-thaw cycles. Peptides containing cysteine, methionine, or tryptophan can degrade through oxidation or disulfide exchange. Working aliquots reduce repeated exposure to moisture and temperature fluctuations during routine analysis.
Purity values do not necessarily predict biological potency. Net peptide content corrects for counterions such as acetate or trifluoroacetate, water, and residual salts. Impurity thresholds for reporting, identification, and qualification are often set according to regulatory guidance, though specific limits depend on the product class and route of administration. Open questions remain about the toxicological relevance of low-level peptide impurities and about how best to compare results across different analytical platforms. A certificate of analysis should state the methods used and the basis for each reported value.
| Property | Value | Notes |
|---|---|---|
| Primary purity method | Reverse-phase HPLC | Separates peptides by hydrophobicity; reports area percent. |
| Identity confirmation | Mass spectrometry | Electrospray or MALDI; matches observed mass to expected sequence. |
| Orthogonal separation | Capillary electrophoresis | Separates by charge-to-size ratio; complements HPLC. |
| Water content | Karl Fischer titration | Water dilutes peptide mass and affects concentration calculations. |
| Counterion | Trifluoroacetate or acetate | Common counterions alter net peptide content in lyophilized powder. |
Handling and storage influence measured purity, and peptides can oxidize, deamidate, aggregate, or adsorb to surfaces over time. Lyophilized powders stored at -20 °C or lower are generally more stable than solutions, though some sequences require different conditions. Repeated freeze-thaw cycles can promote aggregation and loss, so testing after storage checks whether purity has changed. Stability-indicating methods compare stressed and unstressed samples to detect degradation pathways. Light exposure and pH can also accelerate modification.
Solid-phase peptide synthesis can produce truncated sequences when coupling reactions fail. Deletion peptides lack one or more internal residues, while truncation peptides end prematurely. Side reactions include aspartimide formation, oxidation of methionine, and aggregation during chain assembly. Crude synthetic peptides therefore contain target peptide plus related impurities, counterions, residual solvents, and water. Purification by preparative chromatography reduces these impurities but does not remove every closely related species, including some that differ by a single amino acid.
Quality control specifications for peptides typically include appearance, identity, purity by RP-HPLC, water content, counterion content, and residual trifluoroacetic acid. Karl Fischer titration measures water, while ion chromatography or elemental analysis can quantify counterions. Purity specifications may be set at 95% or 98% area percent, but the appropriate threshold depends on the application. For research reagents, a lower purity may be acceptable if identity is confirmed. For assays sensitive to impurities, higher purity and orthogonal testing are often required.
Interpreting chromatographic purity requires attention to detection limits and response factors. Peptides without aromatic residues may absorb weakly at 280 nm, so 214 nm is often preferred, but mobile-phase additives and solvents also absorb at low wavelengths. Co-eluting impurities with different molar absorptivities can produce area percentages that differ from mass percentages. Integration parameters, peak tailing, and baseline choice further affect reported values. For these reasons, method details belong alongside any purity figure, and orthogonal methods are needed to confirm identity and impurity profiles.
Reverse-phase high-performance liquid chromatography is the most common primary method for peptide purity testing. The peptide mixture passes through a hydrophobic stationary phase, and components elute according to differences in hydrophobicity. A mobile phase of water and acetonitrile, often with trifluoroacetic acid as an ion-pairing agent, improves peak shape and retention. Ultraviolet detection at 214 nm records the peptide backbone absorbance, and the main peak area is divided by the total peak area to give an area-percent purity value.
Eculizumab (Soliris) appears to be useful for atypical hemolytic uremic syndrome (aHUS). In September 2011 the U.S. Food and Drug Administration (FDA) approved it as an orphan drug to treat people with aHUS. This approval was based on two small prospective trials of 17 people and 20 people. In the UK, NICE issued guidance on the use of Eculizumab for treating aHUS, based on five evidence sources, including those used by the FDA No randomised controlled trials were identified. All prospective studies were phase 2, open‑label, non‑randomised, single‑arm studies that included patients with different clinical baseline characteristics. The prospective studies lasted 26 weeks; however, patients were allowed to continue treatment with eculizumab in a long‑term extension study. Ravulizumab-cwvz (Ultomiris) is a second generation monoclonal antibody for aHUS made by Alexion pharmaceuticals, Inc. The target of ravulizumab-cwvz is the same eculizumab (Soliris) with changes to the structure of the antibody resulting in a longer serum half life and therefore reduced dosing regimen.
Sedimentation equilibrium experiments reports the molar mass of analytes and their chemical equilibrium constants. The rotor speed is adjusted such that a steady-state concentration profile c(r) of the sample in the cell is formed, where sedimentation and diffusion cancel out each other. Ultracentrifuge Gas centrifuge Theodor Svedberg Differential centrifugation Buoyant density ultracentrifugation Zippe-type centrifuge Reversible Associations in Structural and Molecular Biology (RASMB -an Analytical Ultracentrifugation Forum) Analytical Ultracentrifugation as a Contemporary Biomolecular Research Tool. Archived 2002-08-04 at the Wayback Machine Gilbert-Jenkins theory Archived 2007-05-01 at the Wayback Machine Report on an ultracentrifuge explosion.
For each diprotic acid titration curve, from left to right, there are two midpoints, two equivalence points, and two buffer regions. Due to the successive dissociation processes, there are two equivalence points in the titration curve of a diprotic acid. The first equivalence point occurs when all first protons from the first ionization are titrated. In other words, the amount of OH− added equals the original amount of H2A at the first equivalence point. The second equivalence point occurs when all protons are titrated. Therefore, the amount of OH− added equals twice the amount of H2A at this time. For a weak diprotic acid titrated by a strong base, the second equivalence point must occur at pH above 7 due to the hydrolysis of the resulted salts in the solution. At either equivalence point, adding a drop of base will cause the steepest rise of the pH value in the system.
The C-terminal domain of ADP-ribose diphosphatase contains the Nudix sequence, a highly conserved amino acid sequence that is found in over 450 putative proteins in about 90 different species. A part of this sequence known as the Nudix fold is the catalytic part of the sequence. It is a structurally conserved loop-helix-loop motif that creates a scaffold for metal binding and pyrophosphatase chemistry in the enzyme. ADP-ribose hydrolases in general act as protective agents against excessive intracellular accumulation of ADP-ribose, as high intracellular levels of ADP-ribose can be damaging to the cell. ADP-ribose diphosphatase, in particular, hydrolyzes ADP-ribose into AMP and D-ribose 5-phosphate, both of which are intermediates of central metabolic pathways and therefore are easily reused. Other common names for ADP-ribose diphosphatase include ADP-ribose pyrophosphatase and ADPRase. ADP-ribose is commonly referred to as ADPR.
Sources: en.wikipedia.org
The kinetics of labeled derivatives of apamin were studied in vitro and in vivo in mice by Cheng-Raude et al. This shed some light on the kinetics of apamin itself. The key organ for excretion is likely to be the kidney, since enrichment of the labeled derivatives was found there. The peptide apamin is small enough to pass the glomerular barrier, facilitating renal excretion. The central nervous system, contrarily, was found to contain only very small amounts of apamin. This is unexpected, as this is the target organ for neurotoxicity caused by apamin. This low concentration thus appeared to be sufficient to cause the toxic effects. However, these results disagree with a study of Vincent et al. After injection of a supralethal dose of radioactive acetylated apamin in mice, enrichment was found in the spinal cord, which is part of the target organ. Some other organs, including kidney and brain, contained only small amounts of the apamin derivative. Symptoms following bee sting may include:
Gingras has published > 200 articles that have been cited > 35,000 times (Google Scholar; Feb 2020). In 2011, Gingras was named one of Canada's Top 100 Most Powerful Women. In 2015, Gingras was elected a fellow of the Royal Society of Canada. Her work on interaction proteomics, was awarded, alongside John Yates, the Discovery Award in Proteomics from the Human Proteome Organization (2019). She also received the Jeanne Manery Fisher Memorial Lecture award at the 2019 meeting of the Canadian Society for Molecular Biosciences.
The beta sheet (β-sheet, also β-pleated sheet) is a common motif of the regular protein secondary structure. Beta sheets consist of beta strands (β-strands) connected laterally by at least two or three backbone hydrogen bonds, forming a generally twisted, pleated sheet. A β-strand is a stretch of polypeptide chain typically 3 to 10 amino acids long with backbone in an extended conformation. The supramolecular association of β-sheets has been implicated in the formation of the fibrils and protein aggregates observed in amyloidosis, Alzheimer's disease and other proteinopathies.
Adrenomedullin (ADM) is a peptide hormone that plays an important role in various physiological processes throughout the human body. Initially discovered in 1993 from a pheochromocytoma, a tumor of the adrenal medulla, this 52-amino acid peptide is now recognized for its diverse effects, including vasodilation, regulation of blood pressure, and maintenance of the vascular system. ADM is widely expressed in tissues and also found in the circulation, exerting its influence on the cardiovascular, lymphatic, and endocrine systems, as well as demonstrating anti-inflammatory and tissue-protective properties. In humans, ADM is encoded by the ADM gene. A similar peptide named adreomedullin2 was reported in rats in 2004, which exhibits a similar function.
25499Es + 4820Ca → 302119Uue* → no atoms It is highly unlikely that this reaction will be able to create any atoms of ununennium in the near future, given the extremely difficult task of making sufficient amounts of einsteinium-254, which is favoured for production of ultraheavy elements because of its large mass, relatively long half-life of 270 days, and availability in significant amounts of several micrograms, to make a large enough target to increase the sensitivity of the experiment to the required level; einsteinium has not been found in nature and has only been produced in laboratories, and in quantities smaller than those needed for effective synthesis of superheavy elements. However, given that ununennium is only the first period 8 element on the extended periodic table, it may well be discovered in the near future through other reactions, and indeed an attempt to synthesise it is currently ongoing in Japan. Currently, none of the period 8 elements has been discovered yet, and it is also possible, due to drip instabilities, that only the lower period 8 elements, up to around element 128, are physically possible. No attempts at synthesis have been made for any heavier alkali metals: due to their extremely high atomic number, they would require new, more powerful methods and technology to make.
Sources: en.wikipedia.org
It measures the relative ultraviolet absorbance area of peptide peaks, usually at 214 nm. It does not directly measure mass, water, counterions, or co-eluting species.
HPLC and mass spectrometry answer different questions: HPLC estimates separation purity, while mass spectrometry confirms molecular mass. Orthogonal methods reduce the risk that one technique misses an impurity.
Yes. Area percent excludes water, counterions, residual solvents, and any species that co-elute with the target peak. Net peptide content can therefore be lower than the reported HPLC purity.
Lyophilized peptides are generally stored desiccated at -20 °C or lower, protected from light and moisture. Solutions are often kept at -80 °C in aliquots to limit freeze-thaw damage. Specific sequences may require different conditions based on oxidation or aggregation risk.